In the cold season, a hot water bottle and a teapot will help to protect the heat of your tea. The set is easy to perform, does not require special skills and expensive materials. If you do not have a sewing machine, then it is quite possible to do manual seams. Dimensions of finished products. The diameter of the napkin is 28cm. The height of the heater is 23 cm, the circumference at the bottom of the cup is 72 cm. For work you will need:
- a section of fabric with polka dots for a heater; 90 * 30cm; - a section of fabric for lining heaters 70 * 30cm; - fabric section for flowers for hearts 70 * 13cm; - monotone fabric section for hearts 70 * 13cm; - fabric section for bei and for the “tail” 75 * 6cm;- a piece of padding polyester about 50 * 90 cm. Recall the pattern. It is given in real size and with seam allowances. We translate all the details on the fabric, cut it out.
Spread out all the blanks forassemblies.
We sew a heating pad. We work with polka dot fabric and padding polyester. We sew together 3 “petals”. We make a strip with a length of 8 cm for the “tail”.
Using a needle to pin one piece from the" petals "to the top of the" tail ". We connect two with one line assembled parts. All the synthetic winterizer, which went beyond the basic details, is carefully trimmed.
The front side of the heater is ready.
Similarly, we sew the lining. First, we combine three “petals”, then with one line we combine the two parts into one.
Well iron the resulting blanks.At the same time, the sintepon will be compacted, and the front blank will be reduced.
We connect the lining with the front part of the heater. Two done fix a pin. We place the lining inside exactly, fixing two blanks on all the seams.
We measure the circumference of the resulting workpiece at the bottom. Cut out the strip of the desired length and width 6 cm for the bake
Stitching a strip into a ring, combining it with the wrong side inside and well ironed.
With the help of pins we pin the bake to the front side of the main workpiece. Notice how to pin the bake: cut the bake to the cut of the workpiece.
Sew on the width of the foot tape. With the help of the iron, we turn away the tape and sew with hidden stitches to the lining of the main part.You can also sew on a typewriter, but then a seam of attachment will be visible on the face.
We iron once more the received hot-water bottle. We proceed to the napkin.Collecting hearts and a circle. On the width of the foot we grind all the details, leaving a hole of 2.5 cm on the inversion of the parts. When stitching, pay attention to the sequence of collecting the "sandwich": synthetic winterizer, lining, main fabric. Excess synthetic winterizer cut. Wrenched parts. Well spread out the stitches and sintepon. Manually use the secret stitches to sew holes for turning. Iron off the details.
On a flat surface, lay out the future napkin. Hearts should go to the circle by 0.5 cm. Pinch hearts and hearts with a pin with pins. Hand-held secret stitch connect alldetails of the napkin. Once again, walk the iron well.
Napkin is ready.
Set for the teapot ready. Now you can brew and a large portion of tea and are not afraid that it will quickly cool. Helpers made by your hands will help to keep the tea warm and aroma for a long time.